6
EN
4. Apply foam-compatible medium CA to the strut
mounting slots on both wings. Slide the left
and right struts in the slots between the wings
as shown. Make sure the wings are straight,
level and parallel with each other.
5. Secure the top wing to the fuselage by
applying foam-compatible medium CA where
the upper wing cabane rods meet the fuselage
mounts.
6. When the foam-compatible CA is dry, connect
the left and right linkages between the ailerons
as shown.
7. Remove the battery hatch.
8. Connect the aileron servos from the wings
to the Y-harness connectors in the
fuselage. The left and right aileron servos
can be connected to either side of the
Y-harness.
IMPORTANT:
Correct operation of the AS3X
system requires connection of both ailerons to
the included Y-harness and the AILE channel of
the receiver.
NOTICE:
When disconnecting the servo con-
nectors, do not pull on the servo wires. Use a
screwdriver or pliers to break the friction fi t of the
servo connectors. Failure to do so could result in
damage to the servo wiring.
The blue graphic
should be at the top
of the strut with the
decal at the bottom
facing out.
