Page | 6
Battery and Charger Usage
• Before inserting or removing the battery from this tool,
please set the main switch to the off position.
• To avoid a short circuit to the battery, always use the bat
-
tery terminal cover when it is not in use with the tool.
• When placing the battery into the tool, press the battery
lock before placing it into the battery holder. When remov-
ing the battery, press the battery lock button before pulling
it out of the battery holder.
• Use 100-240V ~ 50-69Hz AC power supply for the charger.
Fully insert the battery into the charger slot and it will begin
to charge automatically as indicated by the charging light.
It will take approximately 74 minutes to fully complete the
battery charge.
• It is recommended to charge the battery between 32°F and
113°F. Do not charge in extreme cold or hot environments.
Machine Operation and Methods
Before inserting and removing the wire coil spool turn the
main power switch to the off position, lock the trigger switch
and remove the battery.
Installing the wire coil spool. Please only use matching
wire without rust in this tool.
Only use original wire coil. Using non-
standard wire or spool could cause the tool
to malfunction.
Remove part of the ad-
hesive tape and cut about 2 inches of wire
from the coil.
Push the reel stopper to
release the reel stay and open the gate at
the same time.
Install the wire coil with the left side fac-
ing the tool. Lock the opening by closing
the reel holder.
Insert the wire into the
wire guide “C” (Note: the wire must not
be bent or curved).
The wire must pass through the wire
guide “C” in between the two feeding
gears until it reaches the end gap. Then
push the wire until it reaches the machine
arm.
Keep pushing the wire until it reaches
the arm “A” unit.
Release the release
stopper and confirm
the release lever has
returned to its original position. (Note:
the wire coil must be clamped the gap of
the feeding gears).
Remove the rest of the remaining adhe-
sive tape from the wire spool.
Install the battery into
the machine, when
you hear a locking
sound the battery has been installed cor-
rectly. (Note: make sure that the main
power switch is in the off position and
that the trigger is locked before installing the battery).
Turn on the main power switch. The machine is now ready
for use.
How to remove the wire coil spool
Turn off the main power switch, lock the trigger and remove
the battery.
Press the release lever and confirm that it is caught in the
open position.
Remove the plastic wire coil spool.
The Tying Procedure
Unlock the trigger lock. Keep the me
-
chanical arm on the rebars to be tied with
a 45° angle at a vertical position to the
rebars.
Press the trigger and the
tool will tie automatically.
Remove the tool when the tying is com-
