DBD-25X Bender ManualB | Page 2
NOTE: When using electric tools, basic safety
precautions should always be followed to
reduce the risk of electric shock and personal
injury, including the followings items:
READ ALL INSTRUCTIONS AND SAVE
THEM FOR FURTURE REFERENCE
1. Keep hands away. From all moving parts and rollers
while operating.
2. Dress properly. Loose clothing or jewelry can get
caught in moving parts. Wear sturdy boots with non-
skid soles. Steel toed boots and safety glasses are recom-
mended.
3. Keep children and bystanders away. Distractions can
cause you to lose control.
4. Do not overreach. Keep proper footing and balance at
all times. This enables better control of the power tool in
unexpected situations.
5. Stay alert. Watch what you are doing and use common
sense when operating a power tool. Do not use a power
tool while you are tired or under the influence of drugs
or alcohol. A moment of inattention while operating
power tools may result in serious personal injury.
6. Do not exceed the maximum number of bars that can
be bent at one time. Please refer to specifications.
7. When positioning the bar between rollers, make sure to
lay it flat on the machine surface. Failure to do so may
cause the rebar to fly out.
8. Do not expose tool to rain or use in damp locations..
Do not use tool in presence of flammable liquids or
gases. Keep work area well lit. If the tool is used out-
doors, keep it covered when not in use and protect it
from rain or water.
9. Do not try to bend materials harder than “Grade 60
or 600N/mm2” as they will either crack and fly out or
cause machine failure.
10. Disconnect tool from receptacle when not in use. Dis-
connect when servicing or changing rollers to prevent
accidents.
11. Keep tool clean at all times for best and safest perfor-
mance. Follow instructions for lubricating and chang-
ing parts. Keep hands dry and free of oil or grease.
Inspect switches, tool cords periodically and have them
repaired or replaced by an authorized service center
if damaged. Check moving parts for alignment and
binding as well as for breakage and improper mounting.
Damaged parts should be repaired or replaced by an
authorized service facility unless otherwise indicated in
this instruction book.
DBD-25X Portable Rebar Bender
1. Moving bending roller
2. Center roller
3. Adjustable stopper
4. Main switch
5. Pilot lamp
6. Operation button On/Off
7. Angle setter (lever type) 2-stops
8. Angle stopper (two)
9. Emergency stop button
10. Plug-in for foot switch
11. Roller set
12. Foot Operated Switch
