BN Products BNCE-20-24V SN, Руководство по эксплуатации и инструкция

Страница: 7 / 16

Page | 7
Maintenance of the Main Unit
Clean the entire unit occasionally by removing dust, debris and oils. Occasionally remove
the flush cutting bottom plate; then remove any cutting chips that remain lodged in the
area the cutting blade rotated.
It is also recommended that the cutting blade be removed and inspected for any materi-
als that did not exit out the chip exhaust area. This should be done after 4-8 hours of use.
Most material cutting chips would normally exit out the chip exhaust area and into the
Cutting Chip Catch Bag. It is recommended that the Cutting Chip Catch bag be emptied
when it becomes 2/3 full of cut material.
RB-BNCE-KNH Blade
The Blade for the BNCE-20-24V Cutting Edge Saw™ should be replaced when the blade is
dull or chipped and a noticeable increase in cutting time has occurred.
To change the Blade, remove the screws that hold the Blade Cover to the Body. Remove
the cover and unscrew the four bolts holding the blade to the Hub. The replacement
blades that you purchase have new screws to be used when installing the new blade. Make
sure that when you remove the blade you clean out any metal debris that has not escaped
the tool.
An optional Steel Mesh Blade is available to improve the cutting capability of the BNCE-
20-24V when cutting mesh materials. (RB-BNCE-MESH)Please see your distributor or
call BN Products-USA, LLC (www.bnproducts.com) for more information.
General Operating Cautions
The following describe the general cautions on operating tool. Always observe the cau-
tions stated in each item.
• Do not press the operation switch if the tool is pointed towards anyone. Operating the
tool by holding it toward anyone may cause injury from contact with the blade.
• Do not apply the Cutting Edge Saw for purposes it is not intended.
• Do not use the tool for lifting or hammering etc. instead, only use this tool for cutting.
Otherwise, the main unit may be broken or damaged, causing injury.
Charger for BNCE-24VLI Battery
Model BNCE-24VCHGR
Input A.C. 120 V 50-60 Hz
Output D.C. 14.4V - 21.6V
Weight 1 lbs. (.45 kgs)