DBD-16X Bender Manual | Page 4
WARNING: ALWAYS UNPLUG THIS TOOL BEFORE
ATTACHING OR REMOVING ROLLERS OR ACCESSORIES.
1.
Select and set the correct rollers for the bars to be bent. See the table.
2. Plug the electrical power cord into an appropriate outlet.
3. Lay the bar on the machine surface between the center roller and bending roller. Adjust the stop-
per so that the bar is parallel to the front edge of the machine.
4. Turn the main switch on and check that the pilot lamp has lit up.
5. Set the angle and make a test bend. If the bent angle is not exact, adjust the angle setter slightly to
the right or left. Lock in the angle stoppers to duplicate the same angle each time.
6.
Push the operation button or foot switch. The moving bending roller will automatically return to
the start position once the bend has been completed.
7.
If it is necessary to stop the machine in an emergency, push the emergency stop button or release
your foot from the foot operated switch. The bending roller will return to the start position auto-
matically.
BENDING ANGLES CAN BE PRESET
1. Set the angle setter to 135° then tighten the right angle stopper to lock the 135° position.
2.
Set the angle setter to 90° then tighten the left angle stopper to lock the 90° position.
3.
Set the angle setter to 135°. Push the operation button to make your first bend.
4.
Slide the rebar to the desired length and set the angle setter to 90°. Push the operation button to
complete your second bend.
For stirrups, cut your rebar to the desired length before bending. Then make both bends for your turn-
downs. Finally make your (3) 90° bends to connect your ends together. See below.
WARNING: Never touch any moving parts or rollers while the rebar bender is being operated.
Содержание AIRMATIC DBD Series
Страница 6: ...DBD 16X Bender Manual Page 6 ...
