BMW VVDI2, Руководство пользователя

Страница: 11 / 50

BMW TOOL User Manual
Ver: 2.0
11
VVDI2-BMW, if the type detect incorrect here, add new key may not work.
Usually have the following types: CAS1, CAS2, CAS3/CAS3+, CAS3++,
CAS3++ (ISTAP), CAS4 etc.
CAS3/CAS3+: This means CAS should be CAS3 (0L01Y) or
CAS3+(0L15Y)(not encrypt version)
CAS3++: This means detected CAS3+ encrypt version
CAS3++ (ISTAP): Means ISTAP version

VIN : Vehicle identification number

Prod. Date : CAS production date

HW : CAS hardware version

FSV : Function software version in CAS

OSV : Operation software version in CAS

Read EEPROM : Support Read CAS1/CAS2/CAS3/CAS3+ (ISTAP version not
support) EEPROM. For CAS1/CAS2/CAS3 type require CAS PLUG; CAS3+ can use
OBDII or CAS PLUG. Attention: the read EEPROM for CAS3+ is not the whole
EEPROM dump, you can
’t write it to CAS with BDM programmer, it can use to
prepare dealer key with File Make Key

Write EEPROM : Support write CAS1/CAS2/CAS3 EEPROM dump, requires CAS
PLUG

Save to File / Load From File : Save the reading data / load EEPROM dump to buffer

Read KM : Read KM stored in CAS system, support CAS1/CAS2/CAS3/CAS3+
(ISTAP version not support). CAS1, CAS2, CAS3 require CAS PLUG; CAS3+ can
access by OBDII and CAS PLUG

Write KM : Write new KM to CAS, support CAS1/CAS2/CAS3/CAS3+ (ISTAP version
not support). CAS1, CAS2, CAS3 require CAS PLUG; CAS3+ can access by OBDII
or CAS PLUG
Attention: KM shown on instrument stored not only in instrument, but also in
CAS system, it can synchronize CAS and instrument and choose the bigger
one for standard. So, when you want change KM, you
’d better take instrument
away from car, set CAS KM to 0,then read EEPROM dump from instrument via
BDM programmer, use File Change KM option to change instrument EEPROM
KM to a new KM, write back the new EEPROM dump to instrument and install
instrument on car

Read Code : Read DME and EGS code from CAS

Write Code : Write DME and EGS code to CAS system. Attention: We
don’t
recommend general user write this code, the car will stop working if write error
code

Synch DME-CAS : Synchronize DME and CAS. Don
’t use this function if all key
lost. If sometimes add key for CAS1/CAS2/CAS3 by OBD cause cars not start, then
you can use this function, refer Special Note 2

Synch CAS-ELV : Synchronize CAS and ELV, This function can be used when ELV