BMW MINI Countryman Cooper, Руководство пользователя

Страница: 163 / 214

Replacing parts
MOBILITY
161
3. Release the bulb holder by pressing down
on the clamping clip, arrow.
4. Take out the bulb holder.
5. Press the bulb in slightly and turn to the left,
take out and change.
6. Re-engage the bulb holder so that it audibly
clicks into place.
7. Reattach the cover.
Licence plate light
5 watt bulb, C 5 W
1. Using a screwdriver, push the light to the left
in the flap of the light housing, arrow
1 .
2. Take out the light, arrow
2
.
3. Change the bulb.
4. Insert the light.
Centre brake light
This light uses LED technology. In the event of a
defect, consult a MINI Service Centre or a work-
shop employing trained personnel and working
to the specifications issued by the manufacturer
of your MINI.
Repairing a flat tyre
Safety precautions in the event of a punc-
ture:
Halt the vehicle as far away from the main traffic
flow as possible, switch on the hazard warning
flashers.
Engage the steering lock in the straight-ahead
position, apply the handbrake and select first or
reverse gear or selector lever position P.
All occupants must leave the vehicle and be led
to a point where they are not exposed to risk, for
example behind a crash barrier at the side of the
road.
If necessary, set up the warning triangle or a
flashing warning light at a sufficient distance to
the rear. Comply with national legislation.
<
In the event of a puncture, the proper procedure
depends on your vehicle's equipment:
> MINI Mobility System, see the following sec-
tion
> Run-flat tyres, page 143
MINI Mobility System*
The Mobility System is located underneath the
left-hand front seat.
Preparations
Use of the Mobility System may be ineffective if
the tyre puncture measures approx. 4 mm,
approx. 1/8 in, or more. Contact the nearest
MINI Service Centre if the tyre cannot be
repaired with the Mobility System so that it is
possible to continue driving.
If possible, leave foreign bodies that have pene-
trated the tyre in the tyre.
Observe instructions for using the Mobility
System on the compressor and sealant
bottle. <
Remove speed limit sticker from the sealant cyl-
inder and attach to the steering wheel.