EN/12
Retrofit / Installation kit No. 82 83 0 140 507
Issue date: 06.2001
Installation Instructions No. 01 29 0 140 511
8.
To install the amplifier (cars without an on-board monitor radio)
0
0
0
0
0
Secure the holder (13) to the amplifier (1) with the
two fillister head self-tapping screws 3.5 x 9.5
(2).Affix the insulation (15) above the edge of the
amplifier to prevent the standard wiring harness
chafing.
0
Before installing the amplifier (4) connect the radio/
amplifier adapter cable
A
to the amplifier.
Connect the adapter cable
A
to the amplifier (1).
Attach branch
A4
, 25-pin connection plug on the
adapter cable
A
, to the plug strip (30) and press it
in the direction indicated by the arrow with a large
flat screwdriver (31) until it audibly engages in the
amplifier casing.
0
Install the amplifier on the A pillar so that the
A pillar trim can be installed again without any
problems.
Check the Bowden cable for the bonnet.
Holes in the body are to be treated with the
anti-corrosion measures set out in BMW
specifications.
Ensure that the insulation strip is on the
standard wiring harness.
Hold the amplifier (1) and holder in position and
mark the mounting points.
Remove the amplifier (1) and drill holes with a
3.5 mm bit at the marked points. Insert the
amplifier (1) and secure it with a Philips screw
4.8x16 (17) in the door and a Philips screw 4.8x30
(12) with a spacer sleeve (16) in the bulkhead.
1
13
2
15
039 0104 B
A4
30
A4
1
A
31
039 0105 B
17
1
16
12
039 0106 B
