PREINSTALLATION
All vehicles with factory pre-wiring should have
the CD audio cable inserted into the (17 pin)
Radio Connector. Before starting installation of
the CD changer, check that the CD audio
cable is secured in place with the Lock Pin
(see Figure 1)
CD CHANGER PREPARATION
Shipping screws are installed on the bottom of
the CD changer to protect the unit during
shipment. Prior to installation, make sure you
remove the shipping screws and cover the
holes with the supplied adhesive seals as
described below.
1. Remove the 3 shipping screws from the
bottom of the CD changer (see Figure 2).
Store the 3 screws for future use; replace
3 screws only if a unit needs to be
returned for an exchange.
2. Cover the holes where the shipping screws
were installed with the 3 adhesive seals
supplied with the unit. (see Figure 2)
3. Change the position of the horizontal /
vertical Spring Pin on both sides of the CD
changer to the Vertical (h position (see
Figure 3). (The unit is shipped with the
Spring Pin in the Horizontal position.)
Page 3
Полезная информация о бмв на www.bmwpost.ru/forum
