This display appears
if the charger is not connected to the battery or the vehicle. Connect the
charger directly to the on-board socket or to the poles of the battery taken from the vehicle using the
adapter supplied. Red charging clip = plus pole, black charging clip = minus pole.
Note:
If the display appears although the charger is connected to the on-board socket, it could be
that the battery in the vehicle is completely discharged. Charging using the on-board socket is not
possible. In this case, disconnect the battery from the vehicle and connect the charger directly to the
battery poles.
This display appears
, if the disconnected charging clips are touching or the battery is connected with
reverse polarity (plus and minus clips of the charger adapters are reversed). Remove the short circuit
or connect the battery with the correct polarity.
Note:
This message is displayed with deep-discharged batteries or residual voltage.
Charging process
: If the battery can be charged, the charging starts. The device works completely
automatically and charges the connected battery according to the charging characteristic. When the
battery is fully charged, the device switches off. In the upper display line, the charging process is
displayed using bars and in per cent. The charging parameters – the charging current and the
charging voltage – are displayed in the lower line.
Charging progress:
With increasing charge, the status display changes. The number of bars and the
percent value increase and show the end of the charging process at 100 %.
The charging duration is
dependent on the charging and aging condition as well as the battery size
.
Содержание 77 02 8 551 896
Страница 2: ......
