BMW 5 series sedan, Руководство пользователя

Страница: 169 / 402

Functional requirements
The setting can only be performed when the ve‐
hicle is stationary. The drive-ready state must be
switched on and the light must be turned off.
Adjusting the sensitivity
Push the turn signal lever to the front for approxi‐
mately 10 seconds. The system responds more
sensitively.
A Check Control message is displayed.
Resetting the sensitivity
Push the turn signal lever to the front again for
approx. 10 seconds or switch off the drive-ready
state.
The sensitivity of the high-beam Assistant is re‐
set to the factory settings.
System limits
The high-beam Assistant cannot serve as a sub‐
stitute for the driver's personal judgment of when
to use the high beams. In situation that require
this, therefore switch off manually.
The system is not fully functional in the following
situations, and driver intervention may be neces‐
sary:
▷ In very unfavorable weather conditions, such
as fog or heavy precipitation.
▷ When detecting poorly-lit road users such as
pedestrians, cyclists, horseback riders and
wagons; when driving close to train or ship
traffic; or at animal crossings.
▷ In tight curves, on hilltops or in depressions,
in crossing traffic or half-obscured oncoming
traffic on highways.
▷ In poorly-lit towns and cities or in the pres‐
ence of highly reflective signs.
▷ When the windshield in front of the interior
mirror is fogged over, dirty or covered with
stickers, etc.
Laser high beams
Concept
The range of the high beams is increased and
ensures an even better illumination of the road.
General information
When the high beams are switched-on, starting
with a speed of approx. 37 mph/60 km/h, the la‐
ser high beams in the headlight are automatically
switched on in addition to the LED high beams.
Depending on the country variant, further infor‐
mation can be obtained from the laser label on
the headlight.
Safety information
The label is in the headlight and is visible from
the outside.
Instrument lighting
Functional requirement
The parking lights or low beams must be
switched on to adjust the brightness.
Adjusting
Adjust the brightness with the
thumbwheel.
Seite 169
Lights
CONTROLS
169
Online Edition for Part no. 01405A11338 - VI/20