Practical interior accessories
86
Practical interior accessories
Integrated universal remote
control*
The concept
The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various remote-controlled devices,
such as door openers and house alarm sys-
tems. The integrated universal remote control
registers and stores signals from the original
hand-held transmitters.
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons
1
. After this, the programmed
memory button
1
will operate the system in
question. The LED
2
flashes to confirm trans-
mission of the signal.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
safety, refer to page
87
.
To prevent possible damage or injury,
before programming or using the inte-
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the pivoting or
travel range of the device being operated. Com-
ply also with the safety instructions supplied
with the original hand-held transmitter.
<
Checking compatibility
If this symbol appears on the package
or in the instructions supplied with the
original hand-held transmitter, you can
assume that the radio remote control device will
be compatible with the integrated universal
remote control.
For additional information, please contact your
BMW Center or call: 1-800-355-3515.
You can also obtain information on the Internet
at:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark of Johnson
Controls, Inc.
<
Programming
1
Memory buttons
2
LED
Fixed-code hand-held transmitters
1.
Switch on the ignition, refer to page
.
2.
When starting operation for the first time:
Press both outer memory buttons
1
for
approx. 20 seconds until the LED
2
flashes.
all stored programs are cleared.
3.
Hold the original hand-held transmitter at a
distance of approx. 2 to 8 in/5 to 20 cm from
the memory buttons
1
.
The required distance between the
hand-held transmitter and the mem-
ory buttons
1
depends on the system of the
respective original hand-held transmitter
used.
<
4.
Simultaneously press the transmit key on
the original hand-held transmitter and the
desired memory button
1
on the integrated
universal remote control. The LED
2
flashes
slowly at first. As soon as the LED
2
flashes
rapidly, release both buttons. If the LED
2
does not flash rapidly after approx. 15 sec-
onds, alter the distance.
5.
To program other original hand-held trans-
mitters, repeat steps 3 and 4.
Online Edition for Part-No. 01 41 0 159 813 - © 09/05 BMW AG
Содержание 2006 325i Sedan
