BMW 11 12 2 157 664, Руководство по установке, Страница: 18 / 35

9. Installing the retrofit wiring harness on RHD cars
2/2011 01 29 2 160 471 © BMW AG, Munich. (Z/Z) 18
9. Installing the retrofit wiring harness on RHD cars
Screw branch A1 on B+ support point X2219 from the
top or bottom.
Screw branch
A2 onto earth pins X175 .
Route branches A6 – A10 to the right-hand rear side
panel.
Route branches
A3 – A5 through the rubber grommet (1)
into the hydraulic unit.
Disconnect the contact from branch A5 .
Push shrink tubing BD over branches A3 – A5 .
Crimp branches BC1 – BC3 to the same colours on
branches A3 – A5 .
Insulate the connections with shrink tubing BD .
Route branches BC4 – BC6 on the left-hand side
into the E-Box.
Cars built before 3/07 only
Connect branch BA3 and BA4 using insulation-piercing
connector BB as follows to the cables of plug X18336 ,
SW 4-pin, of the glovebox light:
- Branch
BA3 , BR cable, to PIN 4 (BR cable)
- Branch BA4 , RT/GN cable, to cable in PIN 1
(RT/GE cable)
Route branches BA1 and BA2 into the E-Box.
Push shrink tubing P over branches BC5 , RT/GN cable,
and BC6 , BR cable.
Crimp branches BA1 and BA2 to the same colours of
branches BC5 and BC6 .
Insulate the connections with shrink tubing P .
Disconnect SW/BL cable from PIN 8 of plug X60101
(GR 26-pin) on the DME control unit, insulate it and tie
it back.
Connect branch
A5 , SW/BL cable, to PIN 8 of
plug X60101 .
A6-A10
A2
X175
A1
X2219
A3-A5
1
090 1456 Z
090 1496 Z
A4
BC3
BC2
A3
BC1
A5
BD
BC4-BC6
X18336
BA3
BB
BA4
BA
090 1497 Z
BC6 BC5
BC4
P
X60101
BA1-BA2
090 1498 Z