BMW Motorrad R 1200GS Adventure 2014, Руководство пользователя для мотоциклиста

Страница: 104 / 193

fault code is the completed self-
diagnosis.
The following unusual riding con-
ditions may lead to automatic
deactivation of BMW Motorrad
ASC:
Driving on the rear wheel
(wheelie) for a longer period
with ASC deactivated
Rear wheel spinning in place
with front brake engaged (burn
out)
Heating up on the main or aux-
iliary stand at idle or with gear
engaged
Switching the ignition off and on
again and then riding the motor-
cycle at a speed of over 10 kph
reactivates the ASC.
With extremely massive-bar tires,
an ASC intervention can occur
before the optimum propulsion
is achieved due to the greater
slip involved. In these cases the
BMW Motorrad ASC should be
deactivated.
If the front wheel loses contact
to the ground during extreme
acceleration, the ASC reduces
the engine torque until the front
wheel touches the ground again.
In this case, BMW Motorrad rec-
ommends turning back the throt-
tle grip somewhat to achieve
a stable driving state again as
quickly as possible.
On a slippery surface, the throt-
tle grip should never be sud-
denly turned back completely
without pulling the clutch at the
same time. The engine brak-
ing torque can cause the rear
wheel to block, resulting in an
unstable driving state. This situ-
ation cannot be controlled by the
BMW Motorrad ASC.
Tire Pressure Control
TCP/RDC
with Tire Pressure Control
(TPC/RDC)
OE
Function
A sensor is located in each tire,
which measures the air temper-
ature and the inflation pressure
inside the tire and sends these
values to the control unit.
The sensors are equipped with a
centrifugal controller, which does
not enable the transmission of
the measured values until after
a speed of approx. 18.5 mph
(30 km/h) is exceeded for the
first time. Before initial recep-
tion of the tire inflation pressure,
--
is shown in the display for
each tire. The sensors continue
to transmit the measured values
for approx. 15 minutes after the
vehicle comes to a stop.
If a TCP/RDC control unit is in-
stalled, however the wheels have
6
102
z Technology in detail