BMW Motorrad K 1600 B 2021, Руководство пользователя для мотоциклиста

Страница: 205 / 294

199
ATTENTION
Excessive current flowing
when the motorcycle is
jump-started
Wiring smoulders/ignites or
damage to the on-board elec-
tronics
If the motorcycle has to be
jump-started connect the
leads to the battery termin-
als; never attempt to jump-
start the engine by connect-
ing leads to the on-board
socket.
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
Use jump leads fitted with
fully insulated crocodile clips
at both ends.
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board
electronics
Make sure that the battery
of the donor vehicle has a
voltage rating of 12 V.
When jump-starting the en-
gine, do not disconnect the
battery from the on-board
electrical system.
Remove the seat ( 94).
Remove the battery cover
( 202).
Run the engine of the donor
vehicle during jump-starting.
Begin by connecting one end
of the red jump lead to the
positive terminal of the dis-
charged battery and the other
end to the positive terminal of
the donor battery.
Connect one end of the black
jump lead to the negative ter-
minal of the donor battery,
then connect the other end to
the negative terminal of the
discharged battery.
Start the engine of the vehicle
with the discharged battery
in the usual way; if the en-
gine does not start, wait a
few minutes before repeat-
ing the attempt in order to
protect the starter motor and
the donor battery.
Allow both engines to run for
a few minutes before discon-
necting the jump leads.
Disconnect the jump lead
from the negative terminal
first, then from the positive
terminal.