5
C
HARGE YOUR CONTROLLER
1.
Insert your charger into a socket and then connect your controller to it. It will
take approximately 2-3 hours to fully charge the battery. Your controller is fully
charged when all three sections of the battery icon are full. The battery icon
will flash when the battery is low and needs to be recharged.
2.
Always disconnect your controller from the charger when the battery is fully
charged.
G
ARMENT SET
-
UP
3.
Connect the controller to the garments. The controller and garments
must be connected properly for your
FLEX ARMS
by BMR to work. “Click” the
controller connector into the garment connector.
4.
Place the garments with the four silver studs facing towards you. Remove
the adhesive GelPads from their pack. You will notice that one side of each
GelPad has a
grid pattern
on it while the other side is
black
.
5.
Remove the covers from the
patterned side
of the four GelPads. Place
the
patterned side
of the GelPads over the silver studs and within the white
lines.
6.
Remove the covers from the
black side
of all four GelPads. Do not throw
these away as you will need to put them back onto the GelPads at the end
of your session.
I
MPORTANT
:
Before you increase the intensity, make sure that all of the silver studs are
completely covered by the GelPads. Press the edges of each one firmly onto the
material before use. You should only use
SLENDERTONE
GelPads as other kinds
may reduce the effectiveness of the exercise.
3
6
4
1
2
7
English
TFB Arms IM Rev 5 Backup_Layout 1 08/05/2017 10:36 Page 9
