BMG Imports LW550, Руководство пользователя

Страница: 6 / 12

Install “Magnetic Brackets”
One magnet bracket MUST be installed at each end of your gate, attached to
your rack. Supplied is a high bracket and a low bracket, when installed they
are designed to trigger the internal magnetic limit switch. This will stop the
gate cycle BEFORE making contact with the physical gate stops.
The best way to install the ‘magnetic brackets’ is to close the gate to hit the
stop, slide back open 50mm, now slide the LOW magnet bracket along the
racking until you see ‘L 6 ’ light up on the main control board, then adjust
magnet on bracket and secure. To install HIGH magnet, open gate full and
pull back 50mm, now slide the HIGH magnet bracket along the racking till
you see ‘L 7 ’ light up on the main control board, then adjust magnet on
bracket and secure.
Check that both fully open and fully closed ‘magnetic brackets’ are in place on
the gear rack and are functioning correctly. Check both fully open and fully
closed physical stops are securely in place.
Closing direction
Closing direction
K3
L1 L2 L3 L4 L5 L6 L7
LED9
LED8
F
FORCE TORQUE
STUDY
wireless receiver
SLOW THRUST
HIGH magnet
end
HIGH magnet
end
LOW magnet
end
L6 & L7 LEDs
5/1 1