1. Marking the Waterfall Location for Mounting on a Wall (For 48” model only).
If you choose not to mount the Watergarden to a wall, please go to section ‘3’ (Installing and
Operating your Water Feature).
a. Locate
your
Level.
b. Draw a line on the wall indicating the top of the waterfall. See Fig 1.A. Measure the
distance between the top of your fountain and the center of the wall bracket. Use those
measurements and on the wall, draw a line down from the line made in Fig 1.A to
indicate your mounting location. See Fig 1.B.
c. Using a level, hold the Wall Bracket (G) to the wall with the top angled towards you. Mark
both mounting holes on the wall. Remember to double-check your level. See Fig 1.C. &
1.D
2. Mounting the Wall Bracket
a. To install the 3 x EZ Anchors™ (I), gently tap or press the tip into the drywall and
slowly screw the anchors into the wall. If you encounter a wall stud while installing an
EZ Anchor™ (I), use the mounting screw without the anchor. Make sure the flat side
of the anchor is flush with the wall. Do not over-tighten the anchors as this will render
them ineffective, as well as damage the drywall. See Fig 2.A & 2.B. We only suggest
using the provided EZ Anchors™ (I) since each EZ Anchor™ (I) has a weight
capacity of up to 50 pounds. Plastic anchors are not an acceptable substitute.
b. Install the Wall Bracket (G) using the 3 x 1” screws provided. Fig 2.C illustrates a
correctly installed wall bracket.
2.A
2.B
2.C
1.C
1.D
1.A 1.B