IP250UHD
USER MANUAL
Contact:
|
|
15
InfraRed Pass-Through (Display Control)
Using the ACM200 control module, IR can be routed independently from any IP250UHD-TX to any IP250UHD-RX unit for
display control, regardless of the current video stream routing between a receiver and another transmitter.
Instructions for the confiuguration of Fixed Routing can be found in the ACM200 User Manual, downloadable from the
Blustream website. The commands for fixed routing can be found at the rear of these manuals.
The IRE1 - IR emitter is connected to the IR OUT socket on the IP250UHD-RX and the bud should be located directly on
top of the IR receiver window of the display device.
Link
RX
TX
CH Select
IR
IR
Rx Tx Gnd
RS-232
CH
IP100UHD-RX
MULTICAST UHD
1
2
3
4
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
MUL
TI
CAST
Third Party
Control System
Link
RX
TX
CH Select
IR
IR
Rx Tx Gnd
RS-232
CH
IP100UHD-RX
MULTICAST UHD
MENU
Link
RX
TX
C
H
Select
IR
IR
Rx
Tx
Gnd
RS-232
CH
IP100UHD-RX
MULTICAST UHD
MENU
Connections:
When using third party 12V IR control solutions please use Blustream IRCAB cable for IR conversion from 12V to 5V. If
the control system uses a 5V IR line, then a straight-through stereo 3.5mm cable can be used. Connect the IR output of
the third party control system to the IR IN of the IP250UHD-TX.
