18
Fig. 18.1
1
2
3
Connection to the mains water
supply
Check that the mains pressure is between
1 bar and 3,5 bar. To enhance the quality
of the sparkling water dispensed, an
incoming flow rate in excess of 3,5 lt/min is
recommended.
Connect incoming water tube Ø8 mm (2)
to the drinking-water main, ideally with a
tap upstream of the unit.
The unit is equipped with a safety valve
and a non-return valve.
Connect waste pipes (3) and (1) to a
waste water manifold. Once the pipes are
attached, turn on the tap. Ensure there are
no leaks.
Before drinking the water from the system,
perform a thorough rinse of the circuit by
dispensing water from each product line.
CAUTION!
To connect the water cooler to the mains
water supply, you will need to use a new set
of connectors (joints, gaskets and pipes).
Do not use a set of connectors that has
already been used elsewhere.
The water pressure entering the unit must
be between a minimum of 1,0 bar (0,10
MPa) and a maximum of 3,5 bar (0,35 MPa)
