5
5 Propane only-proper hose connection
After the cylinder is placed inside the heater,
secure the cylinder with block belt tightly
The heater must be fixed on a stable and strong
table with a minimum height of 40cm from the
floor level.
7.
Leak test
WARNING!: Risk of fire
Proper Hose Connection
WARNING! Ensure the hose does not
contact any high temperature surfaces,
or it may melt and leak causing a fire.
WARNING: Danger of explosion
Never use an open flame to check for gas leaks. Be certain no sparks or open flames
are in the area while you check for leaks. Sparks or open flames will result in a fire
or explosion, damage to property, serious injury, or death
A leak test must be done before initial use, annually, and whenever any gas components
are replaced or serviced Do no smoke while performing this test, and remove all sources
of ignition. See leak testing diagram for areas to check. Turn all burner controls to the off
position Turn gas supply valve on
Brush a half-and-half solution of liquid soap and water onto all joints and connections of the
regulator, hose manifolds and valves
Bubbles will indicate a gas leak Either tighten the loose joint or have the part replaced
WARNING: Chocking harzard
This product contains small batteries
Swallowed small batteries can cause
chocking hazard Seek immediate medical
attention if batteries are swallowed or
inhaled Keep children away from the small
batteries
6
AAA
Battery
(1.5 V)
6
Unscrew the switch button, load small battery,
tighten the switch button
23
