16
4. Parallel setting
Caution!
Make sure that the pre-
selector has been set to
position (set-up).
• Press start button and keep de-
pressed
- the vertical drilling unit will move
downwards
• Pull worktable forwards till ruler rests
snugly against adjusting blocks
• Clamp down table in this position
• Check angle of drilling head and
correct if necessary
!
• Firmly tighten adjusting screws (E4)
at the front
• Push additional centring devices
(E2) outwards until they rest against
centre squares and fasten with hex
set screws (E3)
• Release start button
- the vertical drilling unit will return to
its initial position
• Tighten adjusting screws (E4) at the
back
Adjusting MZK.2880 to ruler
E
352&
(1
352&
(1
(
(
(
Содержание PRO-CENTER 2000
Страница 25: ...25 ...
Страница 26: ...26 Notes ...
Страница 27: ...27 Notes ...
Страница 28: ...28 Id Nr 173 399 0 Printed in Austria BA 17 02 EN 01 2002 BAU0003173112 IDX05 ...