Bluewater Pro 400BC-HR, Руководство пользователя

Страница: 9 / 184

09
© Bluewater Group 2022
EN
Installation
Pro must supply purified water directly to a faucet or storage
tank designed for reverse osmosis purified water. The purified
water must not travel through any non approved pipes or
faucets because this can cause corrosion damage.
Installation must comply with applicable local plumbing codes
and regulations.
Only connect the water purifier to the cold water supply.
The water must be of sufficient quality and meet the
“REQUIREMENTS FOR INLET WATER to water purifier”.
If the Pro is not installed correctly, it will not be covered
under warranty.
The first time Pro is connected to water and power, the
INSTALLER MUST initiate a commissioning flush. This 60 minute
flush is a VERY IMPORTANT flush and must be allowed to
continue to completion. Keep Pro connected to power, with the
purified water faucet open for the entire time. Do not interrupt
this flush. Do not drink the water until this flush is complete. See
Complete User Manual for instructions on commissioning flush.
We recommend that the water purifier is installed by a Bluewater dealer. Installation
instructions can be found be in the Complete User manual and on
www.bluewatergroup.com.
Leak protection system
A sensor at the bottom of the water purifier senses water leaks. If there is a leak, the inlet water
supply is stopped. The water purifier cannot be started again until the leak has been repaired.
Low pressure protection
If Pro stops because of low inlet water pressure, the cause of
the low inlet pressure must be resolved.
Low pressure restart function
The low pressure restart is a function to ensure maximum availability of water.
If Pro has stopped due to low inlet water pressure, Pro attempts to restart automatically,
and continues restart attempts every 5 minutes, for up to 10 times. If the low inlet pressure
problem is not resolved by the 10th restart attempt, Pro will stop.
Once the low inlet pressure has been resolved, Pro can be restarted manually by pressing
the Button for 3 seconds.