7
NMF1010
LED
NEON FLEX
(8)
Warning Mark
Light Surface
Cuttable identifier
Neat and smooth cut
Insert a stick on the reel and place
it on the packing box,and rotate the
reel to get the product.
use in concave direction
Light Surface
Light Surface
use in convex direction
Correct usage of products
Do not use in distortions
Do not bend many times,for it can
endanger electronic lines.
Do not use on wringing(twist)
Do not bend at right angles
Do not throw or pull when taking
products
Do not make irregular cuts.
Warning
Attentions before installation
Do not disassemble or retrofit the light. Do not touch the surface of the light with a sharp object.
Do not do live-line working during installation,especially for high voltage product.
Do not use any organic chemical solvents.
Use neutral glass adhesive to fix this product and it needs to be dried 4 hours in the open environment after operation.
Treat the ends and the circuit connection points that are not connected to the main line with insulation,waterproof, and anti-corrosion in the installation.
Use 18AWG (0.75mm2 cross-sectional area) or thicker core wire to avoid adverse consequences caused by overheating, if the power cable need to
lengthen.
Make sure the input voltage meets the requirements and lines are connected correctly before lighting on
This product is for signage, and do not use as general lighting.
Series connection within the max run.
The length of the power cable between the power supply and the led strip should not exceed 2 meters.Otherwise, large circuit loss will lead to
inconsistent brightness.
Installation, maintenance and repair should be operated by a qualified technician.
Before installation, check that the product parameters are consistent with the requirements (Seeing product specifications or product labels)
Load voltage, current, power and power supply should be matched with the product.
Follow the instructions of wiring diagram (first connect the load and then the power supply) to avoid short circuit
Make sure the correct connection of positive and negative poles between products and power supply. Otherwise, the light will not be on.
Make sure the power cord firmly screwed into the terminal and it should not be pulled out by hands.
The terminal should have waterproof and anti-corrosive treatment.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Содержание NMF1010
Страница 1: ...NMF1010 Top bending Side bending ...
