Hardware User Manual - Sentis3D-M530
Last change: 27 April 2016
Version
2
Bluetechnix ©
Page 17 | 23
6.1
Power Connector (a)
Pin assignment on the power connector:
Connector Type: 2.1mm ID / 5.5mm OD
Voltage: 18-30V
Polarity:
This pins are protected against wrong polarity.
Note
Use inherently limited power sources only!
6.2
GBit Ethernet Connector (b)
This standard RJ45 connector provides a 10/100/1000 Base-T interface to the Sentis3D-M530.
6.3
Extension Connector (c)
The Mini-DIN 8 connector provides several interfaces to connect the Sentis3D-M530 to external devices.
8
5
6
7
3
2
1
4
Figure 6-3 Mini-DIN8 pin out
No.
Signal
Type
Description
1
GND
Power
Ground
2
nRESET
Input (220 k pu) Reset input (active low)
3
TRIGGER_IN
Input (100 k pd) Trigger input, 4 V – 30 V
4
OWIRE
Output
External OWIRE interface
5
MOD_P
Output
External Light modulation signal, differential, positive
6
MOD_N
Output
External Light modulation signal, differential, negative
7
GPIO
In-/Output
General purpose I/O (galvanic isolated) max. 50 V
8
GPIO_Ref_GND Power
GPIO reference Ground (galvanic isolated)
Table 6-1: Power connector pinout
