BlueStar RCS30SB, Инструкция по использованию и уходу

Страница: 22 / 24

22
O
VEN
B
URNER
A
IR
S
HUTTER
A
DJUSTMENT
Before you begin, follow the steps in the Air Shutter Checklist.
Wear heavy duty gloves when removing oven door, oven floor and front panel to prevent injury from
sharp edges.
CAUTION
Oven door weighs about 25 pounds. Use extreme care when removing or replacing to prevent personal
injury or property damage.
Tools needed:
Phillips screwdriver, straight stubby screwdriver or a 3/16” open-end box wrench, heavy duty work gloves
Preparing the Oven for Oven Burner Air Shutter Adjustment
1. Remove oven racks from the oven and set aside.
2. Remove the oven door.

Open the oven door fully so it is parallel to the floor.

Locate the hinge clip within the hinge cavity in the oven frame.

Insert the tip of a flat-head screwdriver into the square opening of the hinge cavity just above the clip.

Use the screwdriver to rotate the clip up and out so it is facing you. Repeat for the other hinge.

Lift up the oven door about halfway, as if closing the door

Observe and remember the hinge position in the hinge receiver before you remove it. It should appear this
way when replacing the door.

With the door halfway up, use your hands to grasp both short sides of the door near the door handle.

Lift the oven door straight up and out from the hinge receiver. Carefully set the door aside.
3. Remove the lower kick panel.

Use a Phillips head screwdriver and remove the sheet metal screws securing the kick panel. Set the screws
aside.

Pull on the kick panel to remove it and place to the side.
4. Remove the oven floor.

Wearing heavy duty gloves, insert your fingers into the holes of the oven floor panel.

Lift panel up and out of the oven. Set aside.
5. Turn on the oven to 300°F and wait 15 minutes.
Do NOT turn on the convection oven during the adjustment procedure.
6. With the oven on, locate the air shutter adjustment screw in the oven cavity. Figure xx.
7. Use a straight stubby screwdriver or a 3/16" open-end box wrench to loosen the air shutter screw.
8. Use your fingers to adjust the air shutter gap:

Widen the gap to remove yellow tips and to eliminate a lazy flame

Reduce the gap to remove a lifting flame.
9. When adjustments are complete, turn off the oven and tighten the air shutter screw with the screwdriver.
ATTENTION
WARNING
CAUTION
ATTENTION