BlueSpot 07945, Руководство пользователя

Страница: 5 / 10

04
Operation
Fitting the connector
The air impact gun is supplied with a male airline quick connector. The quick connector can be
fitted by following the instructions below –
1. Remove the protective cover from the air inlet.
2. Apply PTFE tape (not included) in a clockwise direction to the screw threads of the
quick connector to ensure a tight connection.
3. Screw the quick connector into the air inlet. You may need to use a spanner to ensure
there is a tight connection
4. Connect to airline.
5. Carefully pressurise.
Connecting to the air supply
ALWAYS
ensure the tool is connected to a clean, dry air supply.
ALWAYS
ensure the water is drained from the system daily.
NEVER
exceed the maximum operating pressure stated.
Tool Speed
Use the Air / Torque Control to set and adjust the speed of the impact gun.
1 – Minimum speed
4 – Maximum speed
Forward & Reverse
The forward and reverse function can be used to set the direction of the impact gun. The forward
and reverse switch can be set on the front and back of the impact gun. The letters F and R on the
side of the tool will show whether forward or reverse is set.
Forward – Clockwise rotation
Reverse – Anticlockwise rotation
Installing & removing sockets
ALWAYS
ensure the impact gun is disconnected from the air supply before installing or removing
the sockets.
Installing
1. Firmly push the socket over the locking ring onto the ½” square drive.
2. Make sure the locking ring engages with the socket.
3. Check the socket is firmly attached and there is a secure connection.