Please make sure that you read these instructions carefully in order to avoid injury when
using the brake piston wind back tool. Follow all health and safety rules and regulations. If
in doubt and available please contact a more knowledgeable source.
DO NOT use if damaged.
• Maintain tool in good and clean condition for best and safest performance.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip
shoes.
• Keep children and unauthorised persons away from the work area.
•
ALWAYS
dress appropriately – clothing should be close fitted and long hair tied back.
Jewellery should be removed and shoes should be worn with a non-slip sole.
•
ALWAYS
wear the correct PPE equipment.
•
ALWAYS
ensure you work in a well ventilated room.
•
ALWAYS
check for missing or damaged parts before use.
•
ALWAYS
check the vehicle for broken or damaged parts that could impact on the tools
operation.
•
ALWAYS
ensure you feel comfortable and confident in knowing what you are doing with
the brake components and brake lines. If you feel unsure or have questions please seek
professional advice.
•
ALWAYS
ensure the correct adaptor is used for the vehicle. Refer to manufacturer’s
instructions to see whether the left or right threaded brake piston wind back tool is
needed.
•
ALWAYS
refer to the manufacturers instructions when lifting, removing wheels or
dissembling the braking system.
•
ALWAYS
refer to the manufactures instructions when reassembling the braking system
or wheels.
02
Safe use
(continued)
•
ALWAYS
ensure that a correctly calibrated torque wrench is used when reassembling
the braking system and re-fitting the wheels.
•
DO NOT
operate the tool if you are tired as this could be dangerous.
•
NEVER
operate the tool if you are under the influence of drugs or alcohol as this
is dangerous.
•
NEVER
make modifications to the tool.
•
ALWAYS
stop using the tool straight away if you start to experience discomfort or pain.
Consult with a qualified health professional if needed.
Introduction
BlueSpot Right Threaded Brake Piston Wind Back Tool - 07916
The BlueSpot Right Threaded Brake Piston Wind Back Tool is specially designed for use
with brake calipers with a right threaded piston.
BlueSpot Left Threaded Brake Piston Wind Back Tool - 07914
The BlueSpot Left Threaded Brake Piston Wind Back Tool is specially designed for use
with brake calipers with a left-handed threaded piston.
Operation
Before beginning always ensure you have read the safe use points from the manual and
that they have all been followed.
ALWAYS
ensure special care is taken when working with the brakes and brake hose.
1. Safely park the vehicle and raise securely on axle stands.
DO NOT
apply the
handbrake if the rear calipers are being removed.
2. Remove the relevant wheel. Refer to the manufacturers instructions.
3. Remove the caliper retaining fasteners.
4. Position caliper away from the brake disc or detach completely.
5. Always ensure wear warning wires are removed from the vehicle if fitted before
removing the brake pads.
6. Remove the worn brake pads from the vehicle.
7. Select the side of the drive key that is matches the holes of the piston as close as
possible.
