T Y P - 7 5 M A G D R I L L
7
Ø
This machine has one primary adjusting point for the travel between the magnetic
base frame and the drill rail. The main way to increase or decrease the users ability
to move the drill by hand is with this system. These are the black hex bolts on the
side of the machine that have a locking nut around them. These are generally used to
tighten up the travel as the brass slides wear over time. Be mindful to evenly adjust
these so that the travel is even and smooth. The ideal travel generally keeps the drill
in place when the user is not using the drill (this is usually on the tighter side)
although individual users needs may vary.
Ø
The gear adjusting point on this machine is on the side of the drill gearbox. To adjust
the gear from low to high (or high to low), depress the black gear shifter and slide to
the opposite side.
o
NOTE: You may need to turn the drill spindle to get the gears to properly
engage while sliding the gear lock. This can be done by hand (with the drill
unplugged).
Ø
The machine has a reverse switch located on the main control panel. This switch has
an “L” and “R” signifying left and right hand tool holder rotational direction.
o
NOTE: This function will only work with the drill in the off position. To
reverse the direction, shut the machine off, wait for the spindle to stop
spinning, toggle the switch the opposite direction and engage the motor
again. The machine should switch rotational direction using this method.
1) Magnetic Base
2) Feed Handle
3) Drill Motor
4) 1-1/4” Spindle/Tool Holder
5) Gearbox with Black Gear Shifter
6) Forward / Reverse Switch
7) Magnetic Base On/Off
8) Motor On Switch
9) Motor Off Switch
