Bluerock Tools 8"Z1, Руководство по эксплуатации

Страница: 12 / 24

8 ” Z 1 C O R E D R I L L
8
TRANSPORTING THE MACHINE
Ø When transporting the machine, always use two hands.
Ø DO NOT transport the machine with bits in the spindle.
Ø If transporting inside a vehicle, it is recommended to transport it on its side so as to
avoid the item falling over.
Ø DO NOT carry the machine by the cord.
Ø DO NOT allow the cord or plug to drag along the floor when transporting.
RUNNING THE MACHINE
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Consider your security and stability as well as the orientation of the machine in the
work area.
o
Consider the work surface material, condition, strength, density and rigidity.
These factors directly affect the tools efficiency.
Ø Secure the machine base to the work surface by using a wedge anchor or other
method to ensure the base does not move.
Ø Use the four leveling bolts on the corners of the base to level the machine.
Ø
After placing the machine in work area, connect a safety chain or strap if necessary.
o
The safety chain should attach to the machine (preferably through the
carrying handle or O bolt) as well as attached to the work area in such a
manner that prevents the machine from detaching or falling from the work
area.
Ø Ensure the feed handles are securely attached to the feed spindle.
Ø Ensure the work surface is free of debris, oil, etc.
Ø Select and set up fluid delivery method or dust system.
Ø If using the machine horizontally with the water system, connect hose to the side of
the machine using the connector.
o
This connector takes standard ¾ ” US garden hose hookup.
o
Make sure the water valve is in the off position.
§ This is generally at a 90 degree angle from the valve hose.
o
Partially turn the water spigot on (usually half a turn).
§ CAUTION: DO NOT turn the hose on fully! You need sufficient water
when using wet type bits. Using too much water pressure can cause
the bits to not cut properly as well as water entering the gearbox.
Ø Select appropriate size cutting bit. See section below for details on securing bit.
Ø Check that the machine is firmly attached to the work area.