Bluerock Tools 8 Z1 TEL, Руководство по эксплуатации

Страница: 9 / 22

1 0 ” Z 1 T E L C O R E D R I L L
6
Operations
Note
THOROUGHLY READ THROUGH THE ENTIRE MANUAL BEFORE OPERATING THIS
MACHINE!
PURPOSE
Ø The purpose of the 10”Z1 TEL Core Drill is to drill through masonry, concrete or other mineral rock types
using annular coring bits.
Ø These drills are designed to be wedged between parallel surfaces using their telescoping base. The
machine can then be turned in a variety of directions to enable angled drilling.
o
NOTE: Make sure the base fits completely on the surface and the base is tightly fastened to avoid
stand movement during drilling.
Ø These machines can be used vertically, horizontally or overhead (inverted) provided an acceptable work
environment.
o CAUTION: If drilling overhead you are only permitted to use dry type core bits with a vacuum
system. “Wet” type holes overhead would allow water into the motor and create an extremely
dangerous situation.
OPERATIONAL PRINCIPLES
Ø The main drilling shaft rotates in a forward clockwise direction. The main drilling motor connects to the
tool spindle to make contact with a surface and slowly bore a hole. Using the feed handles on the side of
the drill, the user can raise or lower the drilling motor.
Ø
These drills are ONLY to be used with diamond impregnated coring bits.
o
When drilling with “wet” type bits, the bit end pulverizes the material and the water brings the
material out of the cut.
o
When drilling with “dry” type bits, the bit end pulverizes the material and dust brings the material
out of the cut.
MACHINE COMPONENTS
Ø The main components of the 10”Z1 TEL are the spindle, gearbox, motor, carriage, drill stand and base. The
spindle is driven by the transfer case and the motor.
o
These components must be not be removed except by a qualified technician. Power must be
disconnected prior to any service.
Chapter
3