Bluerock Tools 8 Z1 TEL, Руководство по эксплуатации

Страница: 5 / 22

1 0 ” Z 1 T E L C O R E D R I L L
2
Ø DO allow machine to reach operating speed before starting a hole.
Ø DO unplug machine while changing or adjusting cutting bits so as not to accidentally turn machine on.
Ø DO remove adjusting wrenches prior to turning the machine on.
Ø DO guard against electric shock by only operating this tool on a properly functioning GFCI (Ground Fault Circuit
Interrupt) circuit.
Ø DO be mindful that power tools can expose an operator to vibrations transmitted trough contact with the machine.
Prolonged exposure can lead to medical issues which should be discussed with a medical professional.
Ø DO tie in a drip loop in the power cord to prevent water from running into the power receptacle.
Ø
DO use a dust extraction system for cutting materials that create dust. The operator should also wear a protective
respiratory device.
Ø DO NOT make adjustments to machine while the machine is running.
Ø DO NOT switch off the machine when it is under load, except in an emergency.
Ø DO NOT remove or modify grounding plug. Only to be used on a properly grounded GFCI circuit.
Ø DO NOT leave the machine running when not in use.
Ø DO NOT hold the work piece by hand or using body. Always mechanically clamp or secure work piece.
Ø DO NOT allow operator to make contact with grounded surfaces such as metal objects.
Ø DO NOT allow liquids to enter the machine’s ventilation system.
Ø DO NOT operate machine outside of machine specifications.
Ø DO NOT touch moving parts while the machine is running as death or dismemberment could occur.
Ø DO NOT operate machine overhead (Inverted) when drilling “wet” type cores.
Ø DO NOT remove machines electrical components while connected to a power source. Only to be removed for service
by qualified personal and put back on the machine after service is complete.
Ø
DO NOT allow children or untrained personal to operate machine.
Ø DO NOT use this machine in the rain or a wet environment.
Ø DO NOT operate in the presence of explosive materials as power tools create sparks which may ignite dust or fumes.
Ø DO NOT drill into an area that may contain a live electrical wire/circuit.
Ø DO NOT use this machine without safely securing to the work piece being drilled.
Ø DO NOT use full water pressure when drilling with “wet” type bits! You only need minimal water to drill with these
machines. Extreme water pressure can cause water to enter the gearbox!
Ø DO NOT operate this machine on a lower voltage as it may result in reduced power level and the machine could
become unstable while cutting. This could also limit the motor life.
o
NOTE: Use of long small gauge power extension cords can result in decreased voltage. As local voltages
can vary, it may be a good idea to test the voltage at the end of the extension cord to ensure proper voltage
requirements are met. You might also consult an electrician to make sure the length of cord matches up
with the proper wire gauge for this size motor. Make sure to use outdoor cords when operating outdoors.
HEALTH WARNINGS
Ø Certain dust created by drilling contains chemicals known to cause cancer, birth defects or other reproductive harm.
The examples of these chemicals are below: