BLUENOTE BELVEDERE VILLA, Руководство пользователя, Страница: 7 / 15

- Moreover, the bearing is threaded on the outside (the only one of its kind) in order to be tightly anchored to the board of the turntable on
its own axis. This allows avoiding the use of glue and anchoring screws that would lock the bearing out of alignment and prevent a fully
rigid and precise coupling.
- The bearing is locked onto a brass ring support specially designed to obtain a perfect plane and at the same time it decouples from the
turntable board.
- The clamp (not screwed) that weighs 300 grams and is made in anodised aluminium has been chosen thanks to its excellent sound
performance.
- The motor, which is AC (synchronous) 24 pole with an extremely high coupling coefficient and very low noise, is moved by a custom
made capacitor. The motor that has a 3 mm stainless steel spindle is directly coupled onto the acrylic board thru a special brass system of
rings able to reduce vibrations at its best.
- The pulley is made in DELRING/ALUMINUM and need to be pushed/locked with Allen bolts onto the motor spindle.
-
N.B.: acrylic and Sustarin® (That is an acetamide polymer) are inert, especially rigid materials which makes them ideal for absorbing
vibrations. With their extremely elevated technical and sound characteristics these materials are easily subjected to small surface scratches.
Particular care must therefore be paid to clean the platter and the turntable with a very soft cloth. Avoid the use of any type of solvent.
Despite not making use of mats, the platter will not ruin new vinyl records and creates a perfect coupling with it.
Construction Features 5
Belvedere
Italian Prestige Floating Turntable
Unpacking & Assembly
This section describes how to assemble and install your BELVEDERE turntable. The instructions are purely descriptive and necessarily generic.
If you have any doubts or difficulties with this procedure please contact your retailer who will know how to assist you:
1) Open all the cartons inside the main box and look that all the components listed in the “content section” are present.
2) Screw down the three threaded bars in the specific holes of the transparent acrylic board. The 2 made of brass bars must be housed in
the front holes, the Stainless steel one in the rear holes. The threaded bars must protrude from underneath the transparent acrylic
board about 10 mm.
3) Screw up the silver anodised aluminium feet on the threaded bars onto the lower part of the transparent acrylic base.
4) Insert the silver anodised aluminium threaded-bar covering tubes into the threaded bars on the upper part of the transparent acrylic
board.
5) Screw up the bolt shaped spring supports with the faced up (bolt shape) onto the head of the threaded bars and fit the conical springs
onto them. The eventual red marked spring must be positioned on the rear support.