Bluegiga IWIP3G - IWRAP - IPHONE 3G, Руководство пользователя

Страница: 78 / 211

78
cc range: 0 – 3 (default = 0)
RXSTART {lo_freq} {highside} {attn}
Enables the receiver in continuous reception at a
designated frequency (
lo_freq ) with a choice of low
or high side modulation ( highside ) and with
designated attenuation setting ( attn ).
highside range: 0 or 1 (default = false = 0)
attn : range: 0 – 15
DEEPSLEEP
Puts the module into deep-sleep after a delay of half a
second until woken by a reset or activity on UART.
PCMLB {pcm_mode}
Sets the PCM to loop back mode, where the data read
from PCM input is output again on the PCM output.
If pcm_mode = 0, module is slave in normal 4-wire
configuration
If pcm_mode = 1, module is master in normal 4-wire
configuration
If pcm_mode = 2, module is master in Manchester
encoded 2-wire configuration
PCMEXTLB {pcm_mode}
Sets the PCM to external loop back mode, whereby
the data written to PCM output is read again on the
input. Check is made that the data read back is the
same as that written.
The external loop back may be a simple wire.
Modes are save as above.
LOOPBACK {lo_freq} {level}
Receives data on set frequency lo_freq for data
packets and then retransmits this data on the same
channel at output power
level .
CFGXTALFTRIM {xtal_ftrim}
This command can be used to set the crystal
frequency trim value directly from iWRAP. This is not
a permanent setting!
xtal_ftrim range: 0 – 63
PCMTONE {freq} {ampl} {dc}