Bluebird BP50, Руководство пользователя

Страница: 3 / 33

2 3
BP50
MANUAL
Part 15.105 (B)
Note : This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications, However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user’s authority to
operated the equipment under FCC rules.
FCC 15.407 (g) states
Manufacturers of U-NII devices are responsible for ensuring frequency stability such that an emission
is maintained within the band of operation under all conditions of normal operation as specified in
the users manual.
Since this is an Indoor Only device (required for this band) you do not need to worry about
the extreme frequency Stability over wide temperatures, but you can show that the frequency
Generation portion of this device (from the schematic) has its own stated stability that would never
allow the device to generate emissions or part of the spectrum outside of the authorized band (can
be determined by looking at the Occupied BW plots to see how much margin to the band edge is
available).
If the devices in the future use the other higher frequency UNII bands, and the devices can be
used outdoors, you may need to provide details of stability over a much wider temperature range
(depending on the use conditions stated in the manual).
Most compliance for this requirement is stated from the specification of the frequency generation
portion of the device and not necessarily through additional testing.
Hereby, Bluebird Inc. declares that this BP50 is in compliance with the essential
requirements and other relevant provisions of directive 1999/5/EC.
Use only power supplies listed in the user manual.
Adaptor Info
- Manufacturer : K-tect (Switching Power Supply)
- Model : KS038405
- Input : 100-240~0.4A, 50~60Hz
- Output : 5V / 3.0A
FCC (Federal Communications Commission)
CE
Warning label (IEC 60417-6044)
To prevent possible hearing damage, do not listen at high volume levels for long periods.
This device complies with Part 15 of the FCC`s Rules. Operation is subject to the following
two Conditions:
1. This device may not cause harmful interference, and
2. This device must accept ant interference received, including interference that may
cause undesirable operation.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition
that this device does not cause harmful interference.
The antenna must be installed such that 0 cm is maintained between the antenna and
users, and the transmitter module may not be co-located with any other transmitter or
antenna.
End users cannot modify this transmitter device. Any Unauthorized modifi cation could
void the user`s authority to operate this device.