CR2450
+
PIECES PROVIDED :
ELECTRONIC MODULE :
STRAP :
1
6
5
1
2
3
4
5
6
2
3
4
Top Hooks
Ring
Battery cover
Bottom Hooks
Strap
Strap blocker
IF YOUR SEAT IS EQUIPPED WITH A SHOULDER PAD, VERIFY THAT THE SHOULDER PAD IS SUFFICIENTLY WIDE
(APPROXIMATELY 2 INCHES) TO PERMIT THE POSITIONNING OF THE BLUEBEEP CAR SEAT GUARDIAN® MODULE
INSIDE THE SHOULDER PAD.
WE
CARE
• WE
CONNECT
INSTALLATION OF Bluebeep Car Seat GUARDIAN®
• Open the battery cover by turning it counterclockwise.
• Place the CR 2450 battery, the + above.
• Close the battery cover.
• Pinch the harness shoulder strap into the top and bottom hooks.
• Position the module over the shoulder strap with the battery cover facing forward,
Ring upwards.
• Insert the module into the shoulder pad, as close as possible to the backrest.
• Ensure the distance from the module to the seat back :
-
if the shoulder guard is sewn:
form a loop around the shoulder strap by passing the strap
provided in the module ring.
-
if the shoulder guard is sliding or non-existent:
place the supplied strap blocker in the strap
of the module, then form a loop with this strap by passing it through the ring of the module.
Module, then pass the strap blocker in the strap passage of the backrest.
FINAL TEST:
Avoid any metal parts near (2 inches) from Bluebeep Car Seat
GUARDIAN® which could distort the information transmitted.
Check the mounting direction of the battery.
Ensure that Bluebeep Car Seat GUARDIAN® is properly positioned in the
shoulder guard, and close to the back of the baby car seat.
Make sure the harness straps are not twisted.
In accordance with the recommendations of the baby car seat supplier,
pull the harness to make sure it is well tight and secured, and does not
detach.
Check that the Bluebeep Car Seat GUARDIAN® module does not fit into
the back of the seat.
A
B
C
D
E
A
C
D
E
B
•
•
•
•
•
•
