Blueair Cabin P2i, Руководство пользователя

Страница: 11 / 38

11
4. Attach the mounting strap
6. Connect control knob and 12 V power supply
Connect the control
knob with power supply
into the 12 V power
supply port located near
the driver.
7. Cable management
Route the cable under
carpets or other plastic
details between the
control knob and the
unit. To avoid cable
damage when adjusting
car seats, do not route
the cable too close to
the seat tracks. Coil any
cable excess and fasten
with the supplied cable
tie.
Thread the mounting
strap through the unit
as shown. Velcro side
faces unit.
POWER IN POWER OUT
5a. Choose mounting location
Note: If placed behind a headrest, the strap should
be attached around the supporting rods (or at the
bottom of the headrest), not in the middle of the
headrest.
Placement options
Front/rear headrests, center console
If length adjustments are needed, adjust strap
length on the buckle side (2) of the strap.
5b. Fasten strap to firmly secure unit
Thread the velcro side
(1) through the buckle
and close the strap.
2
1
Make sure the full length
of velcro is engaged
when closing the strap.
Caution:
Attach the unit behind a headrest or on
top of the center console.