NP5767
11
1. LED Display:
Once powered-up, the LED displays the current water temperature automatically.
Note: If pressing is valid, you can hear buzzer and relative indicator light will turn on.
2. Temperature Adjustment Buttons:
Increase and Decrease temperature setting
Press the temperature adjustment buttons and the LED will flash. When it is flashing, you can set the
desired temperature. The value will increase or decrease 1° each time button is pressed. If you hold the
button for 2 seconds, the values will rapidly increase or decrease.
3. Temperature Adjustment Ranges:
Fahrenheit mode: 86°-104°; Celsius mode: 30°- 40°
To lock the control panel, press Increase / Decrease at same time and hold 3 seconds. It may be helpful to
lock the control panel during your absence to avoid changes to your settings. Unlock the control panel by
pressing Increase / Decrease at same time again.
“Temperature Mode” Button:
Press the button to
exchange Celsius mode and Fahrenheit mode.
4. “Bubble Massage” Button:
Press this button to activate the bubble massage system, the green
indicator light turns on. It can be turned off by pressing it again.
NOTE:
a) The massage system will stop automatically after 30 minutes of operation. Re-activate the massage
function by pressing the massage button again.
b) When filter button is on, pressing bubble button will exchange filter mode into massage mode: filter
indicator light will turn off and massage indicator light turn on. If you press the bubble button again, the
massage mode will be changed back to filter mode.
5. Activate Filter System:
This button turns the filter pump on and off. The green indicator light will turn on when the filtration system is
activated.
NOTE: When heating and filter function are on at the same time, pressing button may shut down heating
and filter together. When it is on, filter and heater can not be activated. You should shut down first.
6. Activate Heating and Filtering System at the same time:
Press to activate heating and filtering system at the same time: the green indicator light of filter and red
indicator light of heating will turn on at same time. The pump does not stop heating until the current water
temperature reaches the set temperature. The heating system will restart automatically after the current
water temperature drops 2° below the set temperature. Max. heat temperature: 104°F (40°C)
7. When the filter system has worked 150 hours accumulatively
, a buzzer will sound to
remind you to clean the filter, at the same time, the light of the filtering function will flash. You can hold the
filtering button 5 seconds to turn off the buzzing. The filter system will turn off, you can press the button to
active the filter system again.
8. Temperature Mode Adjustment:
a) Press massage button and the filter button at same time and hold 3 seconds. The control panel will
display “F0””F1” or “F2”. You can adjust the mode by pressing Increase / Decrease buttons.
b) ”F0“ ”F1“ and “F2” means different temperature ranges.
“F0” is for Fahrenheit mode: 86°-104°; Celsius mode: 30°- 40°
“F1” is for Fahrenheit mode: 86°-100°; Celsius mode: 30°- 38°
“F2” is for Fahrenheit mode: 86°-108°; Celsius mode: 30°- 42°
c) Factory settings is “F0” Fahrenheit mode: 86°-104°; Celsius mode: 30°- 40°
NOTE:
If the heat system is activated, the filtration system will automatically start. This is normal.
After turning off the heat system, the filtration system will still work. This is normal.
