-19-
Revision 6/F3503
©
Moffat Ltd, April 2005
E26 Convection Oven
Three Screws
6.3.11 OUTER GLASS
6.3.10 MOTOR
1) Remove fan (refer 6.3.9), remove service
panel (refer 6.2.2), and then remove the
wires that go to the motor.
2) Undo the four screws holding the motor
bracket in place (from the outside) and
remove motor assembly.
3) Remove three screws holding motor to
bracket and remove motor. (fig 6.3.11)
4) Replace and re-assemble in reverse
order.
5) Ensure wire connections are correct
(fig 6.3.12 and 6.3.13)
1) Open the oven door.
2) Lock hinges into position by rotating the
hinge locking clip over the hinge locking
notch.
3) Lift door away from the oven and place on
a flat surface.
4) Undo three screws and remove the trim
from the bottom of the door. Carefully
withdraw the glass.
Figure 6.3.11
5) To replace, ensure that the three silicone
rubber seals are in place, one each side
of the door frame and one on bottom
centre. Clean the inside of the glass and
refit, ensuring that the silicone rubber
seals cover the outer edges of the glass.
Refit the bottom trim, and fit the door to
the oven.
Figure 6.3.15
Three Screws
6.3.12 INNER GLASS
1) Remove the outer glass (refer 6.3.11).
2) Undo three screws and remove the top
trim and handle assembly.
Hinge Locking Clip
Hinge Locking
Notch
Figure 6.3.14
Figure 6.3.12
Screws (4)
Phase
Terminal
Earth /
Ground
Neutral
Screws (4)
60 Hz
Terminal
50 Hz
Terminal
Earth /
Ground
Neutral
Figure 6.3.13
220 - 240V Motors (from S/N 250979)
220 - 240V Motors (up to S/N 250978)
