20
NOTE: It is imperative that the trivet supports are correctly re-fitted to the appliance to ensure that
the trivets locate correctly and sit flush and level. NOTE that the trivet support front end,
side rail profiles are different at either side and only one of the side rails seat into the cut-
out in the Cooktop. where as the rear end of the trivet support side rail profiles are the same
and have 2 cut-outs to locate into.
b. Refit the burner bowls onto the manifolds protruding
through the splash guards, taking care not to damage
the thermocouple which is close to the manifold.
NOTE: The burner bowl has 2 locating holes drilled into the
base flange, these are to locate the burner bowl to the
cap screw on the gas manifold when re-fitting the
burner bowl onto the gas manifold
(Refer to Figs 6 & 7
on the previous page).
c. Refit the burner caps (cast brass) onto the burner bowls already fitted to the manifold. These are
a loose fit into the burner bowls.
d. Refit the trivets to the top of the appliance, taking note that the trivets are manufactured with a
lip on one edge, the lip must always be fitted to the outer edge (front and back) of the Cooktop.
(Refer to Fig 8).
e. Refit the grease tray to the Cooktop.
Periodic Maintenance
NOTE: All maintenance operations should only be carried out by a qualified service person.
To achieve the best results, cleaning must be regular, thorough and all controls and mechanical parts
should be checked and adjusted periodically by a qualified service person. If any small faults occur, have
them attended to promptly. Don't wait until they cause a complete breakdown. It is recommended that
the appliance is serviced every 6 months.
Gas Control Valve Re-Greasing
The gas control valve should be dismantled and greased every 6 months to ensure the correct
operation of the gas control valve.
To carry out this operation;-
a. Remove the gas control knobs from the gas tap spindles by
pulling the knobs away from the control panel.
b. Remove the drip tray from the appliance.
c. Remove the two screws on the underside of the control
panel, securing the control panel to the hob.
d. Remove the control panel from the front of the appliance.
e. Remove the 2 screws holding shaft plate to gas control
body and remove control shaft and plate.
(Refer to Fig 9).
Note orientation of shaft for correct re-assembly.
f. Using needle nose pliers or similar, pull out gas
control spindle, again noting its orientation.
g. Apply a suitable high temperature gas cock
grease or lubricant such as ROCOL - A.S.P (Anti
scuffing paste) / Dry Moly Paste to the outside of
the spindle.
(Refer to Fig 10).
h. Replace spindle and re-assemble the gas control
in reverse order.
i. Refit the control panel to the appliance and secure
with 2 screws.
j. Refit the knobs to the gas control valve spindles.
Cleaning and Maintenance
For the Refrigeration Cabinet Cleaning and Maintenance refer to the Refrigeration Cabinet
Installation and Operation Manual supplied with the appliance.
Two Screws
Fig 9
Spindle
Fig 10
Notice Lip on
Fig 8
