4
Cleaning / Maintenance
16
© Moffat Ltd, January 2007
Revision 1/
Blue Seal Evolution series G51 Gas Cooktops
solution and a soft scrubbing brush. Note
that the gas control knobs are a push fit onto
the gas control valve spindles and can be
removed to allow cleaning of the front control
panel.
b) Baked on deposits or discolouration may
require a good quality stainless steel cleaner
or stainless steel wool. Always apply cleaner
when the appliance is cold and rub in the
direction of the grain.
c) It should not be necessary to remove the
splash guards covering the burner manifolds
for cleaning purposes. These can be cleaned
in situ.
d) Dry all components thoroughly with a dry
cloth and polish with a soft dry cloth.
e) To remove any discolouration, use an ap-
proved stainless steel cleaner or stainless
steel wool. Always rub in the direction of the
grain.
f) Remove the grease tray and clean with a mild
anti bacterial detergent and hot water solu-
tion using a soft bristled brush.
g) Dry the grease tray thoroughly with a dry
cloth.
Re-Fitting the Components to the Range
a) Refit the trivet supports to the range, ensur-
ing that the trivet supports are correctly fit-
ted.
Note:
It is imperative that the trivet supports
are correctly re-fitted to the appliance to ensure
that the trivets locate correctly and sit flush and
level. NOTE that the trivet support front end,
side rail profiles are different at either side and
only one of the side rails seat into the cut-out in
the range top. where as the rear end of the trivet
support side rail profiles are the same and have 2
cut-outs to locate into.
b) Refit the lower cast portion of the 2 piece
burners onto the manifolds protruding
through the splash guards, taking care not to
damage the thermocouple which is close to
the manifold.
Note: The burner bowl (cast item) has 2 locat-
ing holes drilled into the base flange, these are to
locate the base of the burner to the cap screw on
the gas manifold when re-fitting the burner onto
the gas manifold
.
c) Refit the top part of the burner (cast brass)
onto the lower portion already fitted to the
manifold. This is a loose fit into the lower
part of the burner.
d) Refit the trivets to the top of the appliance,
taking note that the trivets are manufactured
with a lip on one edge, the lip must always be
fitted to the outer edge (front and back) of
the range.
e) Refit the grease tray(s) to the range.
