Contact 1.800.762.1142 for assistance. Do not return to place of purchase.
page no.
7
Checking for Leaks
WARNING: Before using this outdoor
fireplace, make sure you have read, understand
and are following all information provided in
the Dangers and Warnings presented on page
2. Failure to follow those instructions can cause
death, serious injury or property damage.
Burner Connections
Make sure the regulator valve and hose
connections are securely fastened to the burner
and the tank.
If your unit was assembled for you, visually check
the connection between the burner pipe and orifice.
Make sure the burner pipe fits over the orifice.
WARNING: Failure to inspect this connection
or follow these instructions could cause a fire
or an explosion which can cause death, serious
bodily injury, or damage to property.
Please refer to diagram for proper installation.
If the burner pipe does not rest flush to the orifice,
please contact 1.800.762.1142 for assistance.
Tank/Gas Line Connection
Make 2-3 oz. of leak solution by mixing one part
liquid dishwashing soap with three parts water.
Make sure control knob is OFF.
Turn LP gas tank ON at valve.
Spoon leak check solution at all “x” locations
If any bubbles appear turn LP gas tank OFF,
reconnect and re-test. If you continue to see
bubbles after several attempts, disconnect LP gas
source and contact 1.800.762.1142 for assistance.
If no bubbles appear after one minute turn tank
OFF, wipe away solution and proceed.
Lighting
1. Make sure there are no obstructions of airflow to
the gas unit. Spiders and insects can nest within
and clog the burner / venturi tube at the orifice.
A clogged burner tube can lead to a fire beneath
the appliance.
2. Control knob must be in the “OFF” position.
3. Turn on gas at LP gas tank.
4. Push and turn control knob counterclockwise to
“LOW”.
5. Press the electronic igniter and hold for
5 seconds to light burner.
6. Release control knob after 45 seconds.
7. If ignition does not occur in 45 seconds, turn
burner control knob “OFF”, wait 5 minutes, fan
with newspaper or magazine, and repeat lighting
procedure.
8. If igniter does not light burner, use a long match
or long butane lighter.
CAUTION: Before Lighting - Using a shovel
to carefully move the lava rocks to access the
burner.
a. Wearing Heat reistant gloves, position the
lit long match or lit long butane lighter
near the side of the burner.
b. Turn control knob counterclockwise to
“LOW”.
c. Remove long match/long butane lighter.
CAUTION: After Lighting - Using a shovel
and heat resistant gloves, carefully move the
lava rocks back to their proper position, being
careful to avoid the flame.
Installing LP Gas Tank
To operate you will need (1) precision-filled standard grill LP gas
tank (20#) with external valve threads.
Note:
An empty standard grill LP gas tank weighs approximately
18 lbs. A precision-filled standard grill LP gas tank should weigh
no more than 38 lbs.
Need a tank of gas?
Try tank exchange service. It’s easy, fast, safe,
and available at tens of thousands of conveniently located retail outlets
nationwide. You can purchase a new full tank or exchange your empty for a
precision filled one.
Insert LP Gas Tank
WARNING: Make sure LP gas tank valve is closed. Close by turning valve clockwise.
Place precision filled LP gas tank upright into hole in outdoor fireplace body so it is arranged
for vapor withdrawal.
Secure LP Gas Tank
Secure tank by sliding tank retainer chain around the LP gas tank and insert peg into LP gas
tank tray.
Note
: Peg must be inserted into LP gas tank when tank is in LP gas tank tray.
Connect LP Gas Tank
Before connecting, be sure that there is no debris caught in
the head of the LP gas tank, head of the regulator valve or in
the head of the burner and burner ports.
Connect gas line to tank by turning knob clockwise until it
stops.
Disconnect LP Gas Tank
Before disconnecting make sure the LP gas tank valve is OFF.
Disconnect gas line to tank by turning knob counterclockwise
until it is loose.
LP Gas
Connection
LP Gas Valve
with Orifice
Burners
X
X
X
X
X
LP Gas Tank Valve
Control Knob
Operating Instructions
Proper flame height.
Lighting Rod Placement
K
