excessive volume is needed to ensure equal operating condition for
each dispensing step.
1. Press
«EXIT» to enter the mode selection.
2. Press
«Up/Down» to make the
symbol start flashing.
3. Press
«SET» to confirm the selection. The default pipetting
volume will start flashing.
4. Use
«Up/Down» to select the desired pipetting volume.
5. Press
«SET» to confirm the selection of pipetting volume.
The
symbol will then appear.
6. Use
«Up/Down» to select the desired pipetting count.
7. Press
«SET» to confirm the pipetting count. The pipetting
volume will show the total aspirating volume.
8. After the settings are completed, first, press the
START
button to
aspirate the sample according to the pipetting volume. Next,
continue to press the
START
button to dispense the samples
according to the pipetting counts. When the count becomes “0”,
press the
START
button to aspirate the sample again. By pressing
the
START
button, the whole operation cycle will automatically
repeat.
9. MIX Mode
After the settings are completed, Mixing is performed automatically by
holding down the
START
button or pressing once the
START
button, the
pipette also can finish the programming.
1. Press
«EXIT» to enter mode selection.
18
