BP301
www.bpfasteners.com
Page 4
CENTER PUNCH TEST RESULT
1.
If the fastener point is flattened, the material is too
hard for a powder actuated fastening.
2.
If the fastener easily penetrates the material, the
material is too soft.
3.
If the material cracks or shatters, the material is
too fragile.
4.
If the fastener causes a small indentation into the
material, the material is suitable for powder
actuated fastening.
SELECTION OF LOADS AND SAFETY
1.
Always make a fastening test after being sure that
the base material is suitable for powder actuated
fasteners. Failing to determine the appropriate
power level to be used may result in the use of
excessive power, allowing the fastener to pass
completely through the work material, causing
severe injury or death to others who maybe in the
path of the fastener.
2.
All operators must always select the level of the
loads by the power level to avoid the use of
incorrect loading for the same reason as that of #1.
SAFETY AT WORK
1.
Operators and by standers must always wear safety
glasses and approved hearing protection. Failure to
do so can result in blindness or serious eye injury
from debris and hearing loss for unprotected
exposure to constant or repeated noise from the
fastening tool.
2.
Keep the work area clear of by standers and
unnecessary materials that may interfere with the
safe operation of the tool. Operating the tool in a
congested or disorderly area may affect the ability
to operate safely.
3.
Never operate
the tool when flammable or
explosive materials are nearby. Powder loads burn
and create sparks when fired and could ignite these
materials or vapors.
4.
Always provide warning signs within 50' of the area
where fastening is taken place. Sign should state:
"Caution powder actuated tool in use." Failure to
warn others can result in serious injury or death to
them. Contact your supervisor for this sign.
