Blue Pneumatic BP-20CR, Инструкция по эксплуатации, Страница: 7 / 8

Operational guidelines
Insert the battery,only use the battery provided by the original
factory,strictly follow the warning on the battery label.
The number of nozzle is according to the corresponding riveting s pecification,
remove the head housing by hand, use a wrench to replace the nozzle. After the
replacement,install the head housing.
When the switch is pressed,the white LED light on the lower part of the tool lights
up for 10 seconds. If the tool does not move within 10 seconds,the white LED light
will go off ,pressing the switch will repeat the light for the next 10 seconds.
Insert the rivet rod into the nozzle and press it on the workpiece. Press the power
switch until the rivet rod breaks , then r elease the power switch until the tool is
reset. Rivet rod into the mandrel bottle, if the rivet is not break at 1st pull ,
repeat it again. When the rivet rod into the mandrel bottle reaches 2/3, please
empty the bottle to avoid the rivet rod jammed inside of the tool.
Note: only when the rivet rod into the mandrel bottle then can go next operation .
If the motor is overloaded and the current protection is exceeded,the tool will stop
running and the red fault light on top of tool will flash. In this case,please
remove the battery and the nose housing to remove the trouble spots,then install the
battery, press the switch board,and reset the tool to the normal setting . Low
voltage protection,if the battery is empty or low voltage,the tool will be forced by
the circuit protection device power off,the red circuit light on top of tool will
flash.
The specification of the rivet must match the nozzle. For example,a 4.8mm nozzle
should be used with a 4.8mm rivet.
j
j aw is the wearing part. T he j aw t ee th appears wear and can not grip the rivet rod
or the rivet slip ped when pull ing then the j aw s should be replaced.
5