Page 4 of 8
292-2726 Rev. C
7/20/10
3. Just forward of the front tire, on the outermost
bottom edge of fascia, remove two metric bolts
using a 10MM socket. Do this to both sides of the
vehicle. Set bolts aside to reinstall later.
3
3
6. Remove another push pin from underneath, gray
arrow. Remove the two bolts on the side. Using
a 12MM socket, remove the bolt from the horn
bracket, bottom arrow. Do this to both sides of the
vehicle. Set push pins and bolts aside to reinstall
later.
6
6
4. Using a 10MM socket, remove three metric bolts
that run horizontally along the bottom of fascia,
where the belly pan and fascia meet. Set bolts
aside to be reinstalled later.
4
4
5. Remove the metric bolt, using an 10MM socket.
Also remove the push pin above the headlight, gray
arrow. Do this to both sides of the vehicle. Set
bolts and push pins aside to reinstall later. Start
fascia removal by pulling down on the fascia where
it meets the fender, just forward of the front tire.
While still on the side of the vehicle, pull fascia
slightly forward. Do the steps above to both sides
of the vehicle. From the front of the vehicle, pull
fascia forward to remove. Set fascia aside carefully
to reinstall later.
2006-10 Honda Ridgeline
Installation Instructions
BX2239
5
5
