6
ASSEMBLY INSTRUCTIONS
4.
Loosen but do not remove the two set
screws in the yoke. Set screws need
to be loosened enough to fully insert
the downrod.
5.
Feed all the wires coming from the
fan through the downrod and the
downrod ball. Insert the downrod into
the yoke and reinstall the downrod
pin and downrod clip. Then re-
tighten the two set screws.
NOTE:
With wiring extending out of
the downrod, measure 8 - 10 inches
of lead wire and cut the excess wire
with wire cutters.
Then strip ½” of
insulation from the end of each wire.
4
5
