BLUE INK TECH ELD, Руководство пользователя, Страница: 20 / 39

Settings (continued)
ELD Adapter Settings
Most of the data items on this screen are
based on information sent from the BIT ELD
adapter to which your app is connected.
Preferred Device
You can set the currently connected BIT ELD
adapter as your Preferred Device, which will
reduce the time it takes the app to connect to
that ELD for future use. This eliminates the
need for your phone or tablet to make a full
sweep of wireless frequencies before the
connection process starts.
Note that once a Preferred Device has been
set, the app will only connect to that device.
If you use multiple ELDs you should not set
a Preferred Device.
To change your Preferred Device, toggle to
the off position. Once you are connected to a
new BIT ELD adapter you can set it as your
new Preferred Device if desired.
Scan for Other BIT ELD Adapters
If there are multiple BIT ELD adapters in
range of your phone or tablet, the app will
connect to the nearest BIT ELD adapter. You
can check that you are connected to the
correct device by the vehicle listed in your
ELD Adapter Settings or your Current Load
Out on the Home page.
If you need to reconnect to the correct
vehicle's BIT ELD adapter, tap “SCAN” next
to “Scan for other ELDs.”
Light Settings
You can adjust your BIT ELD adapter light
settings to keep the LED on or off. In the
default off setting, the light on the BIT ELD
adapter will go off after 60 seconds of being
in the same status condition.
You can use the LED Dimmer to adjust the
brightness of the ELD's light for daytime or
nighttime driving.
Use Alternate J1708 Address
There are two addresses that can be used
by diagnostic devices to communicate with
your vehicle. If you are using a splitter to
plug more than one device into your
diagnostic port, communication could be
corrupted when both devices are using the
same address. If you experience
communication errors, toggle “Use
alternate J1708 address” to switch the BIT
ELD adapter to the other address.
20