Blue Clean AR525, Руководство пользователя

Страница: 13 / 16

en
13
Unit will not turn
on.
Make sure the power washer is in the “OFF” position. Plug in the
electrical cord to a grounded 120 volt outlet (no electrical extension cord
should be used). If the electrical cord will not plug into your outlet, your
electrical outlet is not properly grounded and should not be used. Use
another electrical outlet. Press the reset button on GFCI power box. If
the color of red is not visible in the little window on the GFCI, unplug
and plug in again. Press reset, and look for the red color in the window,
this should remain red in color. If the color is staying red, turn the power
switch on the power washer to “ON”. Squeeze the trigger on the spray
gun and try again.
If this did not correct the problem, try plugging into another electrical
outlet and repeat the above procedure. If it is still not working, call
Customer Service at 1-866-235-5112.
The high-pressure
(HP) hose will not
connect / stay
connected to the
spray gun. Is
this a spray gun
problem?
In most cases, the spray gun is not the problem. The problem is the
re hose.
or pull the rubber sleeve down until the entire tip is visible plus an 1/8”
tip into the
spray gun. It should “click” into place and will not come out until the
hose is released by pushing in the lever on the underside of the gun.
You may cut away the end of the sleeve with a sharp knife if unable to
move the sleeve down. Be careful not to cut or puncture the hose.
The unit is running
but there is not
Check the water source. Unclog the nozzle on the lance. (See nozzle
cleaning instructions under “Cleaning nozzles”.) Or take off the lance
and just spray out of the spray gun. This will indicate if the problem is
with the lance.
Why is water
leaking where the
high-pressure
hose connects to
the spray gun?
Make sure there is an o-ring at the end of the metal tip of the high
pressure hose. If no o-ring is present, the connection between the
hose and spray gun will leak. O-Ring Kits are available online at www.
arblueclean.com or call Customer Service at 1-866-235-5112 to place
an order.
I can’t remove the
lance from the
spray gun. What
should I do?
Al l lances and the detergent tank are attached and removed from the
spray gun in the same manner. Insert the quick-release end of the
lance/detergent bottle into the spray gun. Press the spray gun and
lance together (about a 1/8”) and turn clockwise. The lance will lock in
place. Remove the lance by reversing this procedure. Press the spray
gun and lance together and turn counter clockwise. The lance will
slide out. Or, hold the spray gun and lance in an upright position with
loosen the connection, and then follow the removal process again. You
may also spray soapy water or a lubricant in the area where the lance
connects to the spray gun.
The power washer
turns on for 2
seconds, shuts
off, and will not
turn back on. Do
I have a defective
unit?
water
is connected, the accessories are assembled properly, and the power
switch is turned on, the power washer may turn on for 1 - 2 seconds to
prime the pump. It automatically shuts off and waits for the spray gun
trigger to be pressed. When the trigger is pressed, water star
through the pump. The water sensor in the pump “senses” the moving
water and automatically turns the power washer on. Or, turn the power
switch to off, hold in the trigger on the spray gun, so that you
have a steady stream of water. While you are holding the trigger
open on the spray gun, at the same time, turn the power switch
on.
TROUBLESHOOTING AND FAQs