5
1 866 907 0122 blubathworks.com
2017-06
COMPLETE INSTALLATION
• Fill the tub with water to the overflow and then drain the tub while inspecting the waste connections below the floor for
leaks. Access from below will be necessary for this step (Fig. 8).
• With the bathtub now in place, wipe off any excess tub and tile caulk and adhesive where the tub meets the floor.
• Run a bead of tub and tile caulk around the bottom edge of the bathtub where it meets the floor. Wipe off any excess
caulk withh a wet cloth (Fig. 9).
Note:
This installation is recommended by Blu Bathworks. Our products must be installed by certified professionals only and
according to our install recommendations as well as federal, provincial / state and local building codes and regulations.
8
9
ALCOVE INSTALLATION USING TILE FLANGE
BT0102 · BT0104 · BT0105 · BT0203 · BT0207
In order to maintain the symmetry of these narrow rim tub models in an alcove installation, the following points
& illustration are provided below.
1. Determine wall finish material and its thickness
2. Install tile flange on corner edge of bathtub using high density silicone above and below
lip of TF.BTSB tile flange as shown in Detail I (exploded)
3. Install bathtub
4. Install wall finish
5. Apply a clear silicone bead where the tub and wall finish meet at the flange location
**Blu Bathworks recommends TF.BTSB Tile Flange (Sold separately)
DETAIL I
DETAIL I (exploded)
Silicone
above & below lip
